Well, here's the story:
My last 2 guitars have been fitted with a pinless bridge design kinda like Elliot guitars invented, with rod pins that let the string end balls hook on to. Unfortunately last night I wasn't paying to much attention (again
) and pushed one of the pins in too far down and its too low to be able to hold the string in place 
if I could get a good grip on the rod I would try to twist and pull it out but that its not the case. too little room in there 
I was thinking if I could some how loosen the CA that holds the rod in place I could just push it thru and that would be it! 
the question is: does any one know of a good way to loose the CA without damaging the bridge? please?
Any help would be more than welcome
Thanks in advance
